6. Formateinstellung
z. B. A 4 Drahtkammbindung ( siehe Abb. )
4. Druckstück von rechts hochziehen,
Probestanzung machen.
MIt Pfeiltaste links oder rechts den Randab-
stand einstellen.
Seitenanschlag bewegt sich so lange wie die
Pfeiltaste gedrückt ist
Wenn notwendig nochmals Probestanzung
durchführen.
Randabstand sollte links und rechts gleich sein.
Bei anderen Formaten oder anderen Stanz-
werkzeugen entspr. Druckstücke ziehen.
7. Einstellung des Randabstands
Mit seitlich links angebrachtem Drehknopf den
Randabstand der Perforation auf den jeweili-
gen Bindedurchmesser einstellen. Die ent-
sprechenden Einstellwerte sind unter dem
Drehknopf angebracht.
Drehknopf
Elektrisch einstellbarer Seitenanschlag.
Max. Verstellweg von 0 - 70 mm.
Achtung!
Seitenanschlag nicht über
0 und 70
hinausfahren, da sich sonst der Seitenanschlag
verklemmen kann.
In diesem Fall Maschine am Hauptschalter
ausschalten, kurz warten und wieder anschalten.
Pfeiltaste Pitch Control drücken, je nach Ver-
klemmung nach links oder rechts und so lange
gedrückt halten, bis der Seitenanschlag wieder
frei ist.
8
Содержание DTP 340 A
