MAINTENANCE/CLEANING INSTRUCTIONS
WARNING/ATTENTION
♦
Disconnect unit from electrical supply circuit at disconnect switch before opening.
Débranchez le cabinet du
circuit d'alimentation en utilisant l'interrupteur de déconnexion avant l'ouverture
♦
Always use parts that are supplied or approved by Vertex. Use of other parts may result in poor performance
and could create a hazardous situation and void the warranty.
Toujours utiliser des pièces qui sont fournis ou
approuvés par Vertex. Utilisez d'autres pièces peut entraîner de mauvaises performances et pourrait créer une
situation dangereuse et annuler la garantie.
♦
Do not use oil, acid or corrosive cleaners. Follow instructions in manual for the appropriate cleaning methods.
N'utilisez pas de nettoyants à l'huile, acides ou corrosifs.. Suivez les instructions dans le manuel pour les
méthodes de nettoyage approprié.
♦ Refer servicing to a qualified electrician under the following conditions.
Confiez l'entretien à un électricien
qualifié dans les conditions suivantes:
♦
When the power cord is damaged or frayed.
Lorsque le cordon d'alimentation est endommagé ou effiloché
♦
When compressor fan, outlet or other electrical components need service.
Ventilateur du compresseur, de
sortie ou d'autres composants électriques besoin de service
♦
If the cabinet is producing unusual noises or odors.
Si le coffret est produisant des bruits ou des odeurs
inhabituels
Vertex aeration systems are designed for low-maintenance and typically only require minimal scheduled
maintenance. Periodic cleaning and/or replacement of the compressor air filter, piston cup, and “Flexing” of the
AirStation™ is required.
Remember to keep cabinet air inlets and outlets free of debris and weed growth to allow normal ventilation. If size
and appearance of any surface boil has decreased from initial installation, perform one or both of the following
maintenance procedures.
GENERAL CABINET CLEANING
♦
Disconnect unit from electrical supply circuit at disconnect switch prior to opening
♦
Using a portable vacuum or rag, remove debris, grass clippings and dirt from inside cabinet
♦
Remove objects blocking the cabinet intake vents
♦
Remove objects blocking the fan exhaust vent
♦
Lubricate the locking mechanism
♦
Lubricate cabinet hinges
♦
Open the valves that were previously closed.
♦
Close the lid and turn on the system for two minutes
♦
Return all valves to their original, balanced positions by aligning the marks you made on the valve bodies before
starting the procedure.
9
Owner's Manual
