Twist-A-Saw
™
Manual
Page 23
Setting up
Adjusting the Depth Guide
The cutting bit should always extend past the depth guide foot by 4mm
(3/16”) more than the thickness of the material being cut .
Example:
If you were to cut 10mm (3/8”) plasterboard, the cutting bit should
extend 14mm (9/16”) past the bottom of the depth guide foot, and therefore
4mm (3/16”) through the 10mm (3/8”) plasterboard .
Follow the steps below to adjust the depth guide .
Part
Action
1
Loosen the Depth Guide locking knob (1) . Slide the Depth
Guide foot (2) up or down to set the desired depth .
2
Tighten the Depth Guide locking knob securely .
3
Re-check the bit depth before cutting . Ensure both the bit
and the collet are securely fastened .
(1) Depth Guide
Locking Knob
(2) Depth
Guide Foot