33
d) Sound-to-Light Mode
• Push the button FUNC (5) until "SoUn" is displayed and push the button ENTER (8).
• Select the desired operating mode with the UP (7) and DOWN (6) buttons:
on
Sound-to-light mode activated
oFF
Sound-to-light mode deactivated
• Push the ENTER button (8) to confirm your selection.
• The effect light is controlled via the installed microphone (9) in time with the music in this mode.
• Set the sound-to-light control sensitivity with the SOUND SENSITIVITY (4) controller. Set this controller
so that the light effect changes in time with the music.
Sound-to-light operation takes precedence over automatic mode. Always switch off sound-to-
light control before choosing any other operating mode.
e) Display Settings
• Push the button FUNC (5) until "Led" is displayed and push the button ENTER (8).
• Use the buttons UP (7) or DOWN (6) to select the desired operating mode:
on:
Display permanently on
oFF:
The display switches off after the last button is pushed
• Push the ENTER button (8) to confirm the settings.
Pushing the FUNC button (5) switches the display on again temporarily.
f) Master-Slave Mode
• Push the button FUNC (5) until "SLNd" is displayed and push the button ENTER (8).
• Use the buttons UP (7) or DOWN (6) to select the desired operating mode:
NASt
Master device
SL 1
Normal slave mode
SL 2
Inverted slave mode
• Push the ENTER button (8) to confirm your selection.
If the device is to be operated as a single device (standalone), it must be defined as a master
device.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices.
In inverted slave mode, the device behaves opposite to the master device.
If the device has accidentally been defined as slave unit in stand-alone operation, the display (3)
shows "StbY" and the effect light is off.
Содержание 1413291
Страница 12: ...12 Übersicht ...
Страница 30: ...30 Overview ...
Страница 48: ...48 Vue d ensemble ...
Страница 66: ...66 Overzicht ...