en
⇒
Switch off the head unit using the on/off switch (7, Fig. 1).
⇒
Tilt head upwards�
⇒
Push in tab on the underside�
⇒
Pull protective glass out�
⇒
Clean/replace the protective glass�
⇒
Push in the protective glass until the tab latches in again�
When sliding the safety glass:
-Do not allow it to get wedged
-Do not bend
-
Use a cloth to avoid fingerprints.
8.3 Removing the cable from the cable duct / guiding it into the cable duct
For various reasons – for example, when connecting an HDMI-Video-Recorder – it may be necessary to
remove cables from the cable duct on the support arm or insert new ones�
See also the illustrated instructions at the end of this manual�
The cable of the power supply of the head is integrated into the support arm and cannot be re-
moved.
8.3.1 Removing cables
⇒
With the exception of the power supply (20, Fig� 12-a), remove all connectors
from the head�
⇒
Pull the HDMI cable straight out of the back and then remove it from the retai-
ning clip�
⇒
Remove the cable duct from the support arm�
⇒
Remove the retaining clip�
⇒
Remove the cable tie at the foot end of the cable duct� Make sure that no ca-
bles are damaged�
⇒
Pull the desired cable out through the ribs of the cable duct�
8.3.2 Inserting cables into the cable duct
Two retaining clips are designed as an insertion aid for inserting new cables�
⇒
Place the cable duct on a flat surface.
⇒
Use the insertion aid to grab the cable already in the cable duct�
⇒
Push the insertion aid together completely�
⇒
With the tapered end first, push the insertion aid into the cable duct 3 or 4 ribs
deep�
⇒
Feed the plug of the cable to be fed through the insertion aid and press the
cable into the cable duct that has been opened by the insertion aid�
Make sure that the plug is inserted from the correct side.
⇒
Hold the cable duct securely behind the insertion aid�
⇒
Pull the insertion aid and plug of the cable to be fed through the cable duct to the other end� Make sure
that the plug does not slip out of the insertion aid�
⇒
Remove the insertion aid�
⇒
Pull the cables through so that they protrude about 20 cm past the cable duct on the side of the
EASY view+ 3D head so that the head is not hindered when it pivots�
⇒
On the opposite side of the cable duct, secure the cables to the cable duct with cable ties so they can-
not slip�
⇒
Clip all the retaining clips onto the cable duct and secure the cable duct to the support arm�
Retaining clips designed as an insertion aid fit on the upper part of the support arm, the other
clips go on the lower part.
⇒
Insert the cables into the head�
⇒
Plug the HDMI cable into the retaining clip and then plug it straight into the socket�
⇒
Reconnect the other side of the cables�
Multiple cables can also be fed through together�
Fig. 40
1.
2.
Fig. 41
Fig. 42
- 21 -
