Renfert 29300050, Быстрый старт

Страница: 11 / 72

EN
Setup
If the device is to be installed in a cabinet, an opening for the exhaust air with the following dimensions
must be provided, in addition to the openings for the suction hoses:
• Circular opening:
Min. 120 mm diameters.
• Rectangular opening: Min. 170 x 65 mm.
Installing the Pinch Valves
⇒ Push the suction pipe (16) onto the suction support on the
extractor and hang the holder (20) onto the holder screws.
⇒ Connect the compressed air tubes to the pinch valves:
-Push the compressed air tube onto the pipe connection
in the pinch valve as far as it will go. There will be a slight
resistance to overcome when attaching.
Connection
⇒ Connect to the compressed air supply system, using a con-
nection kit if necessary (17, Fig. 1).
Observe the minimal / maximum connection pressure, see technical data!
Compressed air should be clean and dry (without condensed water). Wet compressed air can
damage the unit.
⇒ Shorten the suction pipes for both extraction points to the required length with a knife.
⇒ Screw the PVC end bushings onto the suction pipes (left handed thread).
Caution: risk of injury!
When shortening the suction pipe please ensure to cut at a right angle.
⇒ Fit suction hose (18) in intake socket (15) and connect to suction point.
Long suction hoses, tight bends and kinks will considerably reduce the extraction force at the
extraction point.
⇒ Electrical appliances can be connected to the coupler sockets (9, Fig. 1) at the back of the unit. Check
the connections are correct - coupler socket (A, B) - suction hose / pinch valve (A, B).
When connecting electrical appliances to the extraction unit, please ensure that the power con-
sumption of all devices connected to the unit power outlet does not exceed the total maximum
power for connected equipment (see “tech. Data”).
⇒ Insert the mains cable into the plug socket.
Operation
Switching the Unit On
The extractor is put into operation at the on / off switch (3).
Stand-By
In the stand-by mode the display is dark.
Leave stand-by mode:
• Press any button
• Switch on any electrical appliance connected to the extractor.
18
15
16
20
MENU
A B
OFF
ON
A B
OFF ON
resetdefault
3
- 3 -