R01US0527EJ0110 Rev.1.10
Page 1 of 39
Oct.8.2021
1. Introduction
This start-up guide describes how to use the RZ/V2M Linux Package.
This guide provides the following information:
•
Building procedure
•
Preparation for use
•
Boot loader and U-Boot
•
How to run this Linux package on the target board
•
How to create a software development kit (SDK)
This RZ/V2M Yocto recipe is a basic package to operate built-in Linux and software on the RZ/V2M Evaluation
Kit. Please contact your Renesas representatives if you have any questions about this package.
1.1
RZ/V2M Linux BSP Package files
Refer to
“RZ/V2M Linux Package Release Note” (hereafter, release note) for the contents of files included in
this package.
1.2
Environmental Requirement
Figure 1-1 shows the recommended environment for this package.
This environment uses the equipment and software listed in Table 1-1. Also, refer to Chapter 3 for the board,
switch, cable, and SD setting.
Figure 1-1. Recommend environment
RZ/V2M Evaluation Kit
Linux PC
Writing
micro-SD Card
Windows PC
Serial to Micro-USB cable
RZ/V2M
RZ/V2M Board
RZ/V2M Base Board
