RTE0T00020KCAA0000J
User's Manual
R20UT5065EJ0100 Rev.1.00
Page 4 of 8
Dec 2021
4.3 Shutdown the Power Supply
(1) Shut down user system power
Shut down the power supply of the user system.
(2)
Shut down the power supply of the emulator
Disconnect the USB cable between the host machine and the E2 Emulator to turn off the E2 Emulator
power.
5. Jumper Pins (JP1 - JP6) Settings
The jumper pin settings differ depending on the software used. If you are using the debugger (e2studio), see
Section 5.1. If you are using the Renesas Flash Programmer, see Section 5.2.
5.1 Settings when using the debugger (e
2
studio)
Set the jumper pins (JP1 - JP6) of this product according to the settings of the debugger (e2studio).
When the setting of (2) in Figure 5.1 is
JTAG
, set the jumper pins (JP1 - JP6) of this product according to
JTAG
in Table 5.1.
When the setting of (2) in Figure 5.1 is
SWD
, set the jumper pin (JP1 - JP6) of this product according to the
SWD
in Table 5.1.
(1)
(3)
(2)
Set the debugger (e2studio) as follows.
(1) Debug hardware: Set according to the type of emulator.
E2 (ARM) / E2 Lite (ARM)
(2) Type: Set according to the communication I/F.
JTAG / SWD
Speed (kHz): AUTO
(3) Power Target From The Emulator (MAX 200mA): Yes
Power Target via: User Interface
Supply voltage (V): 3.3
Figure 5.1 Debugger (e
2
studio) settings
Table 5.1 Jumper pin (JP1 - JP6) settings when using the debugger (e
2
studio)
JTAG
SWD
JP1
JP2
JP3
JP4
JP5
JP6
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
JP1, JP6:
1-2 (TMS)
JP2, JP4:
1-2 (RA)
JP3, JP5:
1-2 (DEBUG)
JP1
JP2
JP3
JP4
JP5
JP6
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
1
2
3
JP1, JP6:
2-3 (SWDIO)
JP2, JP4:
1-2 (RA)
JP3, JP5:
1-2 (DEBUG)
