User's Manual
R20UT2886EJ0100 Rev.1.00
Page 6 of 9
Jan 20, 2014
6. Use procedure
Use this product (R0E510Y47LVB00) by the following procedure.
Connecting this product with emulator.
Connect CN1 of this product with user interface connector of E1 emulator using 14-pin user interface cable.
↓
Connecting this product with user system
Connect CN2 or CN3* of this product with user system.
(Note* Choose by Target MCU.)
↓
Connecting the emulator with host machine
Connect the emulator with host machine using USB cable.
↓
Starting debugger
Start debugger and download user program.
(When you start debugger, you set a setting for using low voltage OCD board.
About the method of detail setting, refer to user’s manual of debugger)
↓
Turning on the power supply of user system
Turn on the power supply of user system. You can start debug.
↓
Turning off the power supply of user system
After finishing the debug, turn off the power supply of user system while user program stop.
(After turn off the power supply, do not operate anything besides exiting debugger)
↓
Exiting debugger
Exit debugger.
↓
Disconnecting the emulator from host machine
Disconnect USB cable from the emulator and host machine.
↓
Disconnecting this product from user system
Disconnect CN2 or CN3 of this product from user system.
↓
Disconnecting this product from the emulator
Disconnect user interface cable from this product and the emulator.
