Renesas R0E436640CPE00, Руководство пользователя

Страница: 60 / 102

R0E436640CPE00 User’s Manual 3. Usage (Emulator Debugger)
REJ10J0918-0300 Rev.3.00 February 15, 2007 Page 60 of 102
3) Specifying a trace area
4) Setting trace write conditions
Specifying a trace area
You can specify a trace range for the trace event.
- Break
64K cycles of instruction execution before the user
program stopped is recorded.
- Before
64K cycles of instruction execution before a trace point
condition was met is recorded.
- About
64K cycles of instruction execution before and after a
trace point condition was met is recorded.
- After
64K cycles of instruction execution after a trace point
condition was met is recorded.
- Full
64K cycles of instruction execution after a trace began is
recorded.
Setting trace write conditions
You can specify a condition for the cycles to be written into
the trace memory.
- Total
All cycles are written into memory.
- Pick up
Only the cycles in which the specified condition was met
are written into memory.
- Exclude
Only the cycles in which the specified condition was not
met are written into memory.
When you have finished setting the trace write condition,
click this button. The Realtime-trace Write Condition dialog
box shown below will appear.
Write mode
Only the cycle in which the specified Start event occurred
A range of cycles from when the specified Start event
occurred to when the specified Start event became
nonexistent
A range of cycles from when the specified Start event
occurred to when the specified End event occurred