Renesas M34286T2-CPE, Руководство пользователя

Страница: 20 / 70

M34286T2-CPE User’s Manual
2. Setup
R20UT0214EJ0200 Rev.2.00 Page 20 of 70
Sep 16, 2010
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to
change settings.
2.1 Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when
the emulator does not start up normally, refer to “5. Troubleshooting” (page 61).
Check the package components Refer to “1.1 Package Components” (page 14).
↓
User registration Refer to “User Registration” (page 12).
↓
Install the emulator debugger M3T-PD72M Install it from the included CD-ROM.
↓
Set the pull-down control switches
Select pull-down resistor connection for pins of D0 to D7,
G0 to G3 and E0.
↓
Connect the USB interface cable
Connect the USB interface cable to the USB interface
connector (J2) of the emulator and the USB port of the host
machine.
↓
Connect the power supply for emulator.
Connect a power supply to the power connector (J1). Power
supply should be 5.0 V ±5%, 2 A.
↓
Connect the user system. Connect the user system as occasion demands.
↓
Turning on the power supply.
Turn on the power to the emulator and the user system as
simultaneously as possible.
↓
Check the LED display of the emulator.
Check that the system status LED, and POWER and
CLOCK of target status LED are lighting. When the user
system is not connected, the POWER LED does not light up.
↓
Start up the emulator debugger. Start up the emulator debugger M3T-PD72M.
↓
Set the operating environment
of the emulator debugger
When the INIT dialog box of the emulator debugger
M3T-PD72M is displayed, click OK button. Then the INIT
dialog box is displayed again, and select the target MCU and
click OK button.
↓
Debug a program with various functions of
the M3T-PD72M
For how to use the M3T-PD72M, refer to the M3T-PD72M
online manual.
Figure 2.1 Flowchart of starting up the emulator