M3028BT2-CPE User’s Manual
2. Setup
REJ10J1457-0300 Rev.3.00 July 22, 2009
Page 36 of 90
2.8.5 Connecting to an 85-pin 0.65mm pitch Foot Pattern
Here following is a procedure of connecting to an 85-pin 0.65mm pitch foot pattern on the user system using the M30280T-
85LGF (included with the M3028BT2-CPE-5). For details on the M30280T-85LGF, refer to its user's manual.
(1) Mount the CSSOCKET085B1007RE01 included with the M30280T-85LGF to the user system.
(2) Attach the J1 and J2 of the M30290T-PTCB to the J3 and J4 of the M3028BT2-CPE.
(3) Attach the M30280T-85LGF to the CSSOCKET085B1007RE01.
85-pin 0.65mm pitch
No. A1 pin
User system
MCU
CSSOCKET085B1007RE01
(*)
LSPACK
(not included)
These corners are not round.
M30290T-PTCB
M30280T-85LGF
(1)
(2)
(3)
LSPACK085B1007RE01(
＊
)
Top cover (
＊
)
Spacer (
＊
)
M3028BT2-CPE
●
: No. A1 pin
*: This product is included with the M30280T-85LGF package.
＊
: These three products are available in one package.
Connecting tools
On-board evaluation with actual MCUs.
(PTLG0085JB-A) foot pattern
M3
02
8B
T2
-CP
E
Figure 2.16 Connecting to an 85-pin 0.65mm pitch foot pattern
CAUTION
Notes on Connecting the User System:
z
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
IMPORTANT
Note on Connectors of the Converter board:
z
The connectors of the M3028BT2-CPE and M30290T-PTCB are guaranteed for only 50 insertion/removal
iterations.
