•
Select FF000 for the Firmware location for the
program. It is recommended that the E8a
firmware location is towards the top of the
memory map.
•
Select 0B00 for the Work RAM location. It is
recommended that the Work RAM is towards the
top of the memory map.
•
Ensure that the checkbox ‘Debugging of program
that uses WDT’ is not checked.
•
Click <Next>.
•
Only ‘Single-Chip Mode’ is available.
•
Clear ‘PM10 (b0 of 000005H) is ‘1’.’
•
Click <Finish>.
•
The Flash Memory write program is downloaded.
•
The Output window in High-performance
Embedded Workshop will state ‘Connected’
Now is a good time to save the High-performance Embedded Workshop session.
Select ‘File’ | ‘Save Session’.
If you have changed any workspace settings now is a good time to save the workspace.
Select ‘File’ | ‘Save Workspace’.
8
