( 22 / 64 )
Chapter 3. Setting Up
With this product, it is necessary to set the following according to your target system. Set the
following after removing the upper cover.
• Setting XIN/XOUT pins
• Setting XCIN/XCOUT pins
• Changing the input frequency
• Setting the MCU peripheral functions
3.1 Removing the Upper Cover
The procedure of removing the upper cover is shown below.
(1) Remove the eight screws of this product and lift off the upper cover (see Figure 3.1).
(2) Set the jumper switches.
(3) Replace the upper cover and secure it with the eight screws.
Figure 3.1 Removing the upper cover
CAUTION
When Removing the Upper Cover:
• Always shut OFF power when removing the upper cover or setting the switches.
(1) Unscrew the eight screws on the sides of this product.
(2) Remove the upper cover.
Содержание Emulation Pod M37760T-RPD-E
