5.6
ENG_UD72378_2
Kit de gonflage des pneumatiques (HFE - Renault)
TYRE PRESSURE KIT
(3/4)
Once the tyre is correctly inflated,
remove the kit: slowly unscrew the in-
flation end piece
3
to prevent any prod-
uct spatter and store the container in
plastic packaging to prevent product
leaks.
– Affix the driving recommendation
label to the dashboard where it can
easily be seen by the driver;
– Put the kit away;
– At the end of this initial inflation op-
eration, air will still escape from the
tyre. You must drive a short distance
in order to seal the hole;
– Start immediately and drive at be-
tween 12 and 37 mph (20 and
60 km/h) in order to distribute the
product evenly in the tyre; after driv-
ing a distance of 2 miles (3 km), stop
and check the pressure.
– If the pressure is higher than 1.3 bar
but lower than the recommended
pressure (refer to the label affixed to
the edge of the driver’s door), adjust
it. Otherwise, contact an approved
dealer: the tyre cannot be repaired.
3
Precautions when using the
kit
The kit should not be operated for more
than 10 consecutive minutes. The con-
tainer must be replaced after the first
use even if liquid remains inside.
Содержание KADJAR 2021
