Renaissance eZee, Руководство по установке, Страница: 6 / 12

Motor Controller & Battery
Shift to rear to
avoid foot collision
Option 1: Controller inside
battery bag
Shift to rear to
avoid foot collision
Option 2: Controller mounted on
front of rear pannier rack
- OR -
Use cable ties to fasten
controller to rack
Throttle
Remove original hand grip
Slide on ebike throttle
Tighten set screw with Allen wrench
Battery bag hangs on
rear pannier rack
Battery bag hangs on
rear pannier rack
If you plan to ride in hot weather, without pedaling up
steep hills, etc., mount your controller outside of the
battery bag to prevent thermal shutdown
Install twist throttles by replacing hand grip with throttle regulators. For
bicycles with twist grip shifters, a thumb lever throttle may be preferred.
Handlebar display
Wiring
Mount LED Display or Cycle Analyst on Handlebar
- OR -
Standard eZee Kits include an LED battery indicator. Note that the ON/OFF switch
on the LED indicator is not wired up to anything. The Cycle Analyst upgrade
option provides more detailed information on your ebike dashboard and uses
the same connector.
If your Cycle Analyst was purchased as an upgrade option, the configuration
settings are correctly set; if your Cycle Analyst was purchased separately,
adjust your configuration settings according to the specifications section
on
page 10 .
Cable ties
Cable tie
Run ebike wires tidily along your bike frame and secure with cable
ties: avoid over tightening so they do not sever
Slack to allow handlebars to turn corners
without tugging on cable connectors
Motor connector housing
(details on next page)
The electrical components of the eZee kit have all been terminated with mating
and unambiguous connectors between the controller and each of the
components. The throttle, battery pack, and motor must all be plugged into the
motor controller for the kit to function. The display and pedal assist
components are both optional.