REMKO RR 22.0, Операционная технология

Страница: 4 / 20

4
REMKO RR
Carefully read the operating manual
before placing the unit or components
into service for the first time. It provides
useful tips, notes and hazard
warnings to prevent injury and material
damage. Failure to follow the directions
in this manual can endanger persons,
the environment and the equipment
itself and will void any claims for liability.
■
Keep this manual in the vicinity of the
units or components.
■
Only qualified personnel may set up
and install the units or components.
■
The unit or its components must be
set-up, connected and operated in
accordance with the use and operating
conditions stipulated in this manual
and comply with all applicable local
regulations.
■
Modification of the units and
components supplied by REMKO
is not permitted and can cause
malfunctions.
■
Units and components may not be
operated in areas where there is an
increased risk of damage. Observe the
minimum clearances.
■
The electrical power supply is to be
adapted to the requirements of the
units or components.
■
The operational safety of units or
components is only assured if they are
fully assembled and used as intended.
Safety devices may not be modified or
bypassed.
Safety notes
■
Do not operate units or components
if there are obvious defects or signs of
damage.
■
The units or components must be
kept at an adequate distance from
flammable, explosive, combustible,
abrasive and dirty areas or atmospheres.
■
Installation, repair and maintenance
work may only be carried out
by authorised specialists. Visual
inspections and cleaning can be
performed by the operator as long
as the unit is disconnected from the
power.
■
To preclude any risks to persons
originating from the units or
components, appropriate precautions
must be taken when installing,
repairing, maintaining, cleaning or
working on the units.
Intended use
Depending on the design and
equipment, the components are
intended exclusively for installation in
dry rooms and for controlling cold water
indoor units.
Any different or additional use is
non-intended use. The manufacturer /
supplier assumes no liability for damages
arising from non-intended use. The user
bears the sole risk in such cases.
Intended use also includes working
in accordance with the operating and
installation instructions.