REMKO MKT 255 ECO S-Line, Инструкции по эксплуатации и монтажу

Страница: 16 / 28

Conduct the warm exhaust air away
NOTICE!
The exhaust air hose should always be laid
rising in the direction of air flow and must not be
extended!
In cooling mode the unit creates warm moist
exhaust air, which must be conducted away from
the room to be cooled. For this reason it is neces-
sary to plug the exhaust air hose into the outlet
opening on the rear of the unit.
n Ensure that the catches for the exhaust air
hose latch securely into the two openings of
the connection aperture. Do not lay the flexible
exhaust air hose with tight bends and do not
kink it in order to be sure of effective operation
and to avoid this causing damage to air ducting
components!
Fig. 8: Latch the hose into place
n
The exhaust air of the unit contains a certain
amount of moisture. For this reason it is advis-
able to feed the exhaust air to the outdoor area
or to outdoors.
Exhaust air routing variants
You can route the exhaust air out of the building as
follows:
Via a flat nozzle
The flat nozzle supplied can be used in various dif-
ferent ways. It is possible to feed the flat nozzle
through an open window and fasten it by means of
Velcro and a window suction cup (Fig. 9). Likewise
the flat nozzle can be hung in a tilted window
(Fig. 10).
Via a wall pass-through
The hose supplied is firmly attached to a wall pass-
through. A suitable wall pass-through is available
as an accessory (Fig. 11).
Fig. 9: Exhaust air with open window
Fig. 10: Exhaust air with tilted window
Fig. 11: Wall pass-though
NOTICE!
In some circumstances routing the exhaust air
via a firmly attached exhaust air hose, e.g.
through closed doors or windows, can lead to
negative pressure in the room in which the unit
is being used. If this should reduce the perform-
ance of the unit then arrange for the pressure to
be equalised (provide ventilation if necessary
on-site).
REMKO MKT ECO series
16