REMKO MKT 255 ECO S-Line, Инструкции по эксплуатации и монтажу

Страница: 14 / 28

5
"▲/▼- THERMO/TIMER CONTROL” keys
The target temperature can be set by pressing the
"▲/▼" keys. This can be adjusted in a range of 16
to 32 °C in 1 °C steps.
6
"ALARM" display
The condensate arising will be collected in an
internal reservoir, fed to the condenser and evapo-
rated there. The evaporated condensate will then
be fed to the outside via the exhaust air hose. If
the condensate cannot be fed away then a fault
shut-down is initiated along with an LED
6
signal-
ling this. In order to put the unit back into operation
again after this fault shut-down, proceed as fol-
lows:
1. Switch the unit off with the "I/0" key and pull
out the power plug.
2. Place a suitable container underneath the
condensate drain of the internal reservoir.
The condensate drain is located on the lower
centre on the rear of the unit.
3. Pull out the stopper from the condensate
drain and collect the condensate that drains
out.
4. Then insert the stopper once again.
NOTICE!
You will achieve a pleasant room temperature if
you set the desired target temperature max. 4
to 7 °C below the outside temperature.
Infrared remote control
General notes
n With the unit switched on any change to the
settings will be automatically transferred to the
room air conditioner. The proper receipt of data
will be acknowledged with an audible "beep".
n To operate the infrared remote control it should
be pointed towards the receiver. The receipt of
data is only possible if there are no objects
between the transmitter and the receiver.
n If the system is shut down for an extended
period it is advisable to remove the batteries
from the remote control.
NOTICE!
Never use new and used batteries at the same
time, remove discharged batteries immediately
and replace these with new batteries of the pre-
scribed quality as there is a danger of dis-
charged batteries leaking.
Inserting the batteries into the remote control
Before initial commissioning, insert the supplied
batteries (2 each, type AAA) into the remote con-
trol.
1. Slide the battery compartment cover on the rear
of the remote control to open it.
2. Insert the batteries with the correct polarity.
Observe marking in the battery compartment.
3. Close the battery compartment again.
Help save on energy consumption in stand-by
mode! If the device, system or component is not
in use, we recommend disconnecting the power
supply. Components with a safety function is
excluded from our recommendation!
REMKO MKT ECO series
14