• After each use, it is recommended to clean hair from blades using the cleaning
brush or by rinsing the blades under running water. When rinsing the blades it is
necessary to lubricate them once dry. With the unit turned off apply 3 drops of oil
to the moving blade facing up, one drop on each end and one in the middle, then
switch the unit on for a few seconds to distribute the oil, then turn the unit off and
wipe off excess oil.
NOTE:
Do not disassemble the blades.
INSTRUCTIONS FOR USE
Your beard trimmer may be used cordlessly when charged, or alternatively it may be
used while plugged into the mains power outlet. It is advisable not to use this beard
trimmer directly from the power outlet when it has been fully charged, but if while using
the trimmer in cordless mode there is a noticeable drop in power, it can be used directly
from the power outlet.
WARNING:
DO NOT use the product in the shower while it is connected to the power
outlet.
TO USE YOU BEARD TRIMMER:
• Switch the product on by sliding up the on/off switch.
• Always comb your beard or moustache with a fine comb before you start trimming.
To attach the adjustable comb, first ensure the adjustable zoom wheel is set to 1.
Then slide on the desired comb so that the comb rails align into the slots found at
the top of the trimmer head.
• Select the comb length by rotating the zoom wheel upwards to increase the length
and downwards to decrease the length. Please see the table below for the different
length increments.
SETTING
HAIR DESCRIPTION
HAIR LENGTH
1
Stubble or Cropped look
1.5mm
0.06˝
2
2.5mm
0.1˝
3
Short
4mm
0.16˝
4
5.5mm
0.22˝
5
Medium
7mm
0.28˝
6
9mm
0.35˝
7
11mm
0.43˝
8
14mm
0.55˝
9
Long
18mm
0.71˝
• Slowly slide the trimmer through the hair. Repeat from different directions as
necessary.
• If hair builds up in the trimmer comb during the trimming process, switch the unit
off, pull off the comb and brush the accumulated hairs away with your finger.
6
