Remington HC5950, Руководство пользователя

Страница: 6 / 158

6
ENGLISH
, To Attach A Comb
• Hold the comb with its teeth upward
• Guide the comb rails into the slots on the side of the clipper head. Then push the comb
down until it seats on the adjustment arm.
, To Remove The Comb
• Holding the clipper with the blades facing away from you, firmly push the comb
upward and away from the blades.
A
CAUTION
If the incorrect comb is attached to the product for the desired cutting length, a red warning
light will illuminate to indicate this.
Please inspect that the desired comb is attached or that the correct setting is selected on the
comb switch.
F
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair. Do
not force it through quickly. If you are cutting for the first time, start with the maximum comb
attachment
STEP 1 – Nape of the neck
• Set the comb to 3mm or 6mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of
the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time
STEP 2 – Back of the head
With the comb set at 12mm or 18mm, cut the hair at the back of the head.
STEP 3 – Side of the head
• Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to 9mm and
continue to cut the top of the head.
STEP 4
– Top of the head
• Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on
top of the head against the direction in which the hair normally grows.
• For longer hair on top, use the longer length comb attachment (22 – 42mm) to achieve
the desired style.
• Always work from the back of the head.
STEP 5
– The finishing touches
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.