background image

3.   Hold the hair clipper in one hand so that the blades are at the top, and the front 

of the hair clipper is facing you.

4.  Place your thumb of the opposite hand underneath the blades at the front of the unit, 

hold the back of the blade set with your fore finger and middle finger and firmly 
press upwards with your thumb. The blade set will detach from the hair clipper.

5.   Brush the accumulated hair from the hair pocket and blades.
6.   Replace the blade set by inserting the notch (on the inside at the bottom of the 

blade set) into the groove of the hair pocket and firmly push down with the palm of 
your hand until you hear an audible ‘click’ and the blade set is locked into place.

STORAGE

When not in use, unplug the hair clipper and store it out of reach of children in a safe 
dry place. Never wrap the cord around the hair clipper as this will cause the cord to 
wear prematurely and break. Handle the cord carefully for long life and avoid jerking, 
twisting or straining especially at the plug connections.

TROUBLESHOOTING
The hair clipper does not work when turned on:

Hair clipper must be charged for a full 16 hours, or use hair clipper while plugged into wall.

Hair clipper cutters do not move:

The cutting unit may be dirty and clogged. Clean the unit as directed in Cleaning & 
Maintaining section.

Hair clipper does not hold charge:

Fully discharge the battery by running hair clipper until it stops; then follow recharging 
instructions (see section on Charging Your Hair Clipper).

trimming just a little at a time.

STEP 2 - BACK AND SIDE OF THE HEAD

With the 9mm or 12mm setting in place, cut the hair at the back of the head.

STEP 3 - SIDE OF THE HEAD

a.

 With the 9mm or 12mm setting in place, trim sideburns.

STEP 4 - TOP OF THE HEAD

a.

 With the setting of your choice, cut the hair on top of the head against the 

direction in which the hair normally grows.

b.

 For longer hair on top, use scissors. Lift the hair on top of the head with styling 

comb. Cut over the styling comb with the hair lifted or hold the hair between the 
fingers to lift it and cut it to the desired length.

c.

 Always work from the back of the head.

STEP 5 - THE FINISHING TOUCHES

a.

 Use the hair clipper without an attachment comb for close trimming around 

the base and sides of the neck.

b.

 To produce a clean straight line at the sideburns, reverse the hair clipper. 

Place the reversed hair clipper at right angles to the head, tips of the blades 
lightly touching the skin and then work downwards.

 CLEANING & MAINTENANCE

To ensure long lasting performance of your hair clipper, clean the blades and unit 
regularly.

NOTE: Ensure that the hair clipper is turned off and unplugged 

when cleaning.
AFTER EACH USE

1.   Ensure the hair clipper is switched off and disconnected from the mains 

household power outlet.

2.   Brush the accumulated hair from the blades. Do not submerge the hair clipper in water.
3.   To clean the body of the unit, wipe with a damp cloth and dry immediately.
4.   Gently brush the remaining hairs away from the hair clipper comb and hair 

clipper blade. Do not rinse the cutter assembly under water.

EVERY SIX MONTHS

At regular intervals the blade set should be removed and cleaned.
1.   Ensure that the hair clipper is empty of power, is switched off and disconnected 

from the mains household power outlet.

2.   Remove the comb attachment.

2 YEAR

 

WARRANTY

 

HC8008AU

USE & CARE 

MANUAL

PLEASE READ

PRIOR TO USE

HAIRCUT KIT

9

8

7

10

Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited

WARRANTY AGAINST DEFECTS

In this warranty:

Australian Consumer Law

 means the Australian consumer law set out in Schedule 2  

to the Competition and Consumer Act 2010;

CGA

 means the New Zealand Consumer Guarantees Act 1993;

Goods

 means the product or equipment which was accompanied by this warranty and 

purchased in Australia or New Zealand, as the case may be;

Manufacturer, We 

or 

us

 means:

1.  for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd  

ACN, 007 070 573; or

2.  for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,  

as the case may be, contact details as set out at the end of this warranty;

Supplier 

means the authorised distributor or retailer of the Goods that sold you the Goods 

in Australia or in New Zealand; and 

You

 means you, the original end-user purchaser of the Goods.

1.  Our goods come with guarantees that cannot be excluded under the Australian 

Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure 
and compensation for any other reasonably foreseeable loss or damage. You are also 
entitled to have the goods repaired or replaced if the goods fail to be of acceptable 
quality and the failure does not amount to a major failure.

2.  The benefits provided by this Warranty are in addition to all other rights and remedies in 

respect of the Goods which the consumer has under either the Australian Consumer Law 
or the CGA. The original purchaser of the Goods is provided with the following Warranty 
subject to the Warranty Conditions:

3.  We warrant the Goods for all parts defective in workmanship or materials for the period 

of two (2) years from the date of purchase

 (Warranty Period)

. If the Goods prove 

defective within the Warranty Period by reason of improper workmanship or material,  
we may, at our own discretion, repair or replace the Goods without charge.

Warranty Conditions

4.  The Goods must be used in accordance with the manufacturer’s instructions. This 

Warranty does not apply should the defect in or failure of the Goods be attributable to 
misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of 
the user. As far as the law permits, the manufacturer does not accept liability for any 
direct or consequential loss, damage or other expense caused by or arising out of any 
failure to use the Goods in accordance with the manufacturer’s instructions.

5.  Exhaustible components (such as shaver heads, cutters and foils) of the Goods  

are included under this Warranty only where there is a defect in workmanship or 
materials used.

6.  The warranty granted under clause 3 is limited to repair or replacement only.
7.  Any parts of the Goods replaced during repairs or any product replaced remain the 

property of the manufacturer. In the event of the Goods being replaced during the 
Warranty Period, the warranty on the replacement Goods will expire on the same date  
as for the Warranty Period on the original Goods which are replaced.

8.  In order to claim under the warranty granted under clause 3 you must:
 

(a)  Retain this warranty with your receipt/proof of purchase; and

 

(b)  Return the Goods to us at the relevant address below or to the Supplier by prepaid 

freight within the Warranty Period accompanied with (i) the legible and unmodified 

original proof of purchase, which clearly indicates the name and address of the 

Supplier, the date and place of purchase, the product name or other product serial 

number and (ii) this warranty.

9.  This warranty is immediately void if:
 

(a)  Any serial number or appliance plate is removed or defaced;

 

(b)  The Goods have been serviced or otherwise repaired by a person not authorised to 

do so by us or where non approved replaced parts are used.

10.  The Goods are designed for domestic use only. A limited 90-day Warranty applies to any 

industrial or commercial use of the Goods. The Goods must be connected to the electrical 

voltage requirements as specified in the ratings label located on the Goods.

11.  This warranty does not cover the cost of claiming under the warranty or transport of the 

Goods to and from the Supplier or us.

12.  This warranty is only valid and enforceable in Australia against Spectrum Brands 

Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.

Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd 
Chifley Business Park 
1 Chifley Drive 
Mentone, VIC 3194 Australia 
Customer service in Australia: 1800 623 118 
E-mail: [email protected] 
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited 
Building C, Ground Floor 
600 Great South Road, 
Greenlane, Auckland 1051 New Zealand 
Customer service in New Zealand: 0800 736 776 
E-mail: [email protected]

Website: www.remington-products.com.au

REMINGTON SERVICE HOTLINE

 

Australia 1800 623 118 (toll free) 

 

New Zealand 0800 736 776 (toll free)

AUTHORISED REPAIR CENTRES

Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trade Mark of Spectrum Brands, Inc. (SBI), or one of its subsidiaries

 

© 2012 SBI 

Rev. 12/12 

Part No. T22-0001116

This product is not suitable to use in a bath or shower. 

This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.

Содержание HC5005AU











Отзывы: