7
•
Ensure the blades are dry after rinsing under the tap. To reattach, align the blade set
onto the clipper and push the blade set towards the clipper body until it clicks into
place.
•
Place a small drop of cutter or sewing machine oil onto the blades at each end and at
the middle point of the blades. Turn the unit on for a few seconds to distribute the oil
then turn off and wipe off excess oil.
BATTERY REMOVAL
•
The battery must be removed from the appliance before it is scrapped.
•
The appliance must be disconnected from the supply mains when removing the
battery.
•
Ensure the clipper is discharged of all power.
•
Starting at the seam on either side of the charge indicator lens, pry open seam
working back and forth from one side to the other, following the seam until the top
shell has been pried apart all the way from the rest of the clipper. Remove the two
screws from the inner housing.
•
Gently pull the inner housing straight up and away to remove the inner housing
shell.
•
Remove the two screws from the inner structure located on each side of the circuit
board.
•
Gently pull the inner structure containing the battery and circuit board up out of
the lower housing structure of the clipper.
•
From the under side of this inner structure, cut the red and black wires which lead
to the battery.
•
With the inner housing structure right side up, pull upward firmly on the circuit
board to allow room to remove the battery. Pry the battery out of its holder.
•
Dispose of the batteries safely.
•
Содержание HC4255
Страница 2: ...2 Fig 1 Fig 4 Fig 3 Fig 2 f j i e g ...
Страница 11: ...11 ...
