- 2 -
Model # SGF20 (gable mount)
Special installation notes for each model:
SF20
– This is a simple encased panel fan that flashes underneath the leading edge of
your shingles. This unit includes humidistat and thermostat. Make sure you remove the
small plastic bag that has the small thermostat and humidistat (underneath the fan near the
blade) after installation. Also, clip the small plastic tie that will allow the thermostat to
hang (approximately 2 feet) from the unit (to get an accurate attic temperature reading).
Fan operates above 80 degrees Fahrenheit. (26.7 degrees Celsius).
SF25
– See installation instructions for SF20. However, this fan allows the solar power
panel to tilt. Angle the tilt to maximize the sun exposure by tilting towards a south or west
position. Typically, steep pitched roofs will require higher tilt. This fan is also suitable for
houses that face south, so the fan needs to be on the back of the house, but tilted towards
the south.
SF30
– This fan is simply a more powerful version of the SF25 fan.
SGF20
– Get updated manual at
http://remingtonsolar.com/product-manuals/
Gable-mount fan. Simply install vertically using hardware provided. Position panel in
sunny area (preferably south or south west) and run power cable through attic. Drill a hole
from the outside of the roof and push cord through the roof. Be sure to use silicone
roofing sealant to prevent leaks.
Download updated detailed manual at:
https://remingtonsolar.com/product-manuals/
