1D
1S
1U
COM
COM
2D
2S
2U
Up
+
+
....
Down
Stop
Com
+
-
+
-
DOWN
UP
Contact Closure
(Momentary)
Connection
Application
For control by an A/V control system (e.g. AMX or Creston) or a Touch-Contact
Switch (Remaco AVA-200+)
* For this zero voltage Contact Closure, any DC voltage exceeding 3V might
damage the MPC
* Works on momentary contact closure only. (Dry contact, normally open)
To set screen to your desired “up” and “down” positions.
Bottom View
Adjust “
-
” :
screen roll away from frame (anti-clockwise)
screen roll into the frame (clockwise)
Adjust “
+
” :
STOP
Allen Key (# 4mm) to set
limit switch knob
Upper Limit
Lower Limit
Adjust “
-
” :
less screen drop (anti-clockwise)
Adjust “
+
” :
more screen drop (clockwise)
Screen Frame
Lower Limit
Red Knob
Upper Limit
White Knob
Common(Orange)
Up(Purple)
AVA-200+
Important Note
The upper limit and lower limit of the screen had been preset in factory. Any adjustment to these 2 limit
switches may cause damages to the screen fabric. If adjusted, it will cause the following problems:
a) The screen will roll into the frame and stop by force and not by the Upper Limit switch.
This will cause overheating of motor which unable the screen to operate properly.
b) The depression of the bottom bar onto the fabric will cause horizontal mark on screen surface.
c) Adjusting the Lower Limit of the screen any lower than beyond the STOP sticker may cause the fabric
to drop off
Disclaimer
Any adjustment to these 2 limit switches will void the warranty for the screen and Remaco will hold
no responsibility for any damages to it. Please consult us if it is necessary to do any adjustment to the
limit switch.
To set screen to your desired “up” and “down” positions.
Stop(Grey)
Down(Pink)
