OFF
Holding in the lamp key and rotating the channel selector
will raise or lower the frequency by 1
increments.
Disables CTCSS or DCS
Selecting the [o] key switches it from OFF to the first
CTCSS tone. Rotate the channel selector to move the
tone frequency up or down in 1
increments until the
desired tone frequency is reached. If there isn’t an
asterisk shown next to the last digit of the frequency, then
the increment change is 1
if there is an asterisk
shown next to the last digit of the frequency, then the
increment change is
Pressing the
key will
toggle the increment size between 1
and 0.1 Hz.
Selecting the [o] key again switches it from CTCSS to
the first DCS tone. Rotate the channel selector to move
the DCS code up or down until the desired code is
reached. The last alpha character will be an
inverting) or ‘I” (inverting). Pressing the [o] key toggles
the
and ‘I”. Pressing the
key will toggle the DCS
selection between ‘standard’ and “non-standard’ DCS
codes. If there isn’t an
asterisk
shown next to the last
diglt of the DCS code, then the DCS tone selection is
‘standard”; if there is an asterisk shown next to the last
dlgit of the DCS code, then the DCS tone selection is
‘non-standard”. Selecting the
key again switches it
from DCS to OFF.
No DTMF or Two Tone signaling on selected channel.
Allows DTMF signaling on selected channel.
Allows Two Tone signaling on selected channel.
Disables this feature.
SIG OFF
SIG DTMF
SIG TTS
OFF
O N
to be transmitted every time the
SCAN DEL
SCAN ADD
OFF
ON
SHIFT OFF
SHIFT On
TXPWR H
High power is 5 watts. When set to Hi, pressing the [Lo]
button toggles the power from 5 watts to 1 watt or from 1
to 5 watts.
Low power is 1 watt. The [Lo] button will not toggle the
channel to high power. Always set to low power.
Receiver
is
and transmit deviation is
less than
TXPWR L
WIDE
RELM
Page
