5
P2
6
“
H
”
means the transmission of signal for the
radio at the high power;
Display Description
Call
The radio receives a selective call/call alert.
Received indicator.
Monitor State Indicator.
Scan Indicator.
Talkaround
OST Indicator.
Indicator.
2.3 Rear Panel
（
1
）
Antenna Interface
（
2
）
Power Interface
（
3
）
External Speaker Interface
3
．
Basic Operation
①
Startup:
Press the red POWER button for a long time (at least 1.5 seconds)
to switch the radio on/off
②
Volume
Press the
“
MONITOR
”
or
“
Squelch
”
button to listen to the backg-
round noise first, and then adjust the volume by turning the volume con-
trol knob.
③
Channel
The radio can provide 256 conventional channels(
) Press the
“
CHANNEL UP
”
or
“
CHANNEL DOWN
”
button
to select the channel. Press the
“
ZONE UP
”
or
“
ZONE
DOWN
”
button to select the group you require.
④
Transmission
To send a call, press the PTT button and speak to the microphone
in the normal voice. Please keep the microphone about 3 or 4 cm far
from your mouth. After speaking,
16 Zones can be
programmed, from 1 zone to 16 zone, 16 channels is in each zone at
most; Zone 0, which cannot be programmed, includes all the valid ch-
annels .
please loosen the PTT button.
⑤
Receive
The radio will return to the receiving state after you loosen the PTT
button. The distributor may have set the CTCSS/DCS signaling in the
programmed radio of your radio. On the channels with CTCSS/DCS are
set, you can only hear the call from other radio with the same CTCSS/DCS.
