4
Reliant_Back Bar_User Manual_Jan19
REMOTE CO2 GAS CYLINDER INSTALLATION
1. Remove plug on the right wall with a pair of pliers.
2. Drill and bore hole through the wall,holes can be located in two different areas.
3. Insert CO2 line through the hole.
4. Seal hole around CO2 line with silicone sealer to prevent cold air leakage.
When lifting unit do not use the countertop as a lifting point.
• Also remember to leave cabinet upright for 24-hours before plugging into power source.
• Set unit in its final location. Make sure there is adequate ventilation in this location. Under extreme heat
conditions (+100°F / +38°C) an exhaust fan may be necessary.
• Proper leveling of the unit is critical to operating success (for non-mobile models). Effective condensate removal
and door operation will be affected by leveling.
• The cooler should be leveled front to back and side to side with a level.
Warning: Installation without proper ventilation will void the manufacturer’s warranty.
ELECTRICAL
Do not under any circumstances cut or remove the grounding prong from the power cord. For safety, this
appliance must be properly grounded at all times.
• The power cord of this cooler is equipped with a grounding plug which mates with a standard grounding wall
outlet to minimize the possibility of electric shock hazard.
• If the outlet is a standard 2-prong outlet, it must be replaced with the properly grounded wall outlet.
NEVER USE AN ADAPTOR PLUG!
• Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
Check the incoming voltage with a voltmeter.
• DO NOT USE EXTENSION CORDS. The use of extension cords to connect the cooler will void warranty. The
unit must be close enough to the electrical supply so that extension cords are never used.
• The cooler should always be plugged into its own dedicated circuit with a voltage rating that matches the rating
plate. This provides the best performance and also prevents overloading wiring circuits which could become a
fire hazard from overheated wires.
• Never unplug by pulling on the power cord. Always grip the plug firmly and pull straight out from the outlet.
• Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a
power cord that has cracks or abrasion damage along its length or at either of its ends.
• When moving the cooler away from the wall be careful not to run over or damage the power cord.
It is strongly recommended that any servicing be performed by an authorized service representative.
NOTE:
Wiring diagram can be referenced by removing the front louvred grill to view the inside cabinet wall.
