Reliable Equipment REL-LP Series, Руководство оператора, Страница: 12 / 22

12
HOSE/CONNECTOR INSPECTION
ALWAYS DISCONNECT pump/power source and move toggle
switch to OFF before connecting or disconnecting any components.
ALWAYS DEPRESSURIZE
hydraulic system, before slowly
disconnecting this unit or any of the systems components.
ALWAYS INSPECT HOSES AND CONNECTORS
. Replace or
repair if any leakage is evident. Leakage is a sign of deterioration in
component parts. Worn or leaking parts must be repaired or replaced.
Loose or improperly tightened couplings will not allow
fl uid to pass
through the hose creating a blockage in the supply or return line.
Failure to fully comply can result in severe injury or death.
WARNING
CAUTION
DISCONNECTING HOSES
ALWAYS CAP HOSE & TOOL CONNECTORS WHEN NOT IN USE
Turn
fl ow control lever to the OFF position.
Turn hydraulic power source OFF.
CAUTION: TOOL AND/OR HYDRAULIC FLUIDS MAY BE HOT.
CAUTION: TOOL/HOSES MAY STILL BE UNDER PRESSURE.
Follow the sequence below to prevent pressure buildup.
Loosen all connections slowly in case pressure has built up.
Disconnect the pressure hose from the power source.
Disconnect the pressure hose from the tool.
Disconnect the return/tank hose from the tool.
Disconnect the return/tank hose from the power source.
Failure to fully comply could result in severe injury or death.
SERIOUS BURN HAZARD
HOT SURFACES MAY CAUSE SERIOUS BURNS.
The hydraulic cylinder may be hot during and after operation.
CAUTION: HYDRAULIC FLUID MAY CAUSE SERIOUS BURNS.
Never disconnect tool, hoses, or fi ttings while the hydraulic power
source is running or if the hydraulic fl uid is hot.
Failure to observe this warning could result in serious injury.
WARNING