Reliable Equipment REL-EP-115, Руководство оператора

Страница: 21 / 26

21
FIGURE 3
VALVE BLOCK ASSEMBLY
(
R40100
)
31 R40031* O-RING 9
55 13167 BALL 1/4” 3
102 R40102 CAP 1
103 R40103 SHAFT 1
104 R35017 TOP BLOCK / HANDLE BOSS 1
105 R40105 ROTOR 1
106 R40106 GROMMET 3
107 R40107 WAVE SPRING 3
108 R40108 BEARING 1
109 R40109 WASHER 1
110 R40110* O-RING 1
111 R24542 SPRING PIN 3/16 X 1.25 1
112 R40112* V-SEAL 1
113 R35008 SPRING 1
114 R40114* VALVE GASKET 1
115 R40115 STEM 1
116 R40116 RETAINING NUT 1
117 R40117 SELECTOR KNOB 1
118 R40118 SPRING 2
119 R40119 REGULATOR SCREW 1
120 R40120 PINTLE 1
121 13189 REGULATOR SPRING 1
122 R40122 BALL 1/8 1
123 R35018 STUD 1
124 R35019 PLASTIC KNOB 1
125 R35020 SCREW 1
126 R40126* O-RING 3
127 R40127* B/U RING 3
128 R40128 3/32 X 3/4 SPRING PIN 1
129 R40129 SET SCREW 1
130 R40130 SPRING PIN 1/4 X 1/2 1
131 R40063 DUMP PIPE 1
R40101 VALVE BODY 1
It is highly recommended that this unit be returned to RELIABLE EQUIPMENT or
a factory trained and authorized service center for all repair and maintenance.
Complete disassembly is not recommended.
ELECTRIC MOTOR - Refer to the manufacturers (supplied) motor Operators Manual for
Operation, Care & Maintenance information.
All maintenance or disassembly should take place on a
fl at, clean work surface covered with
towels or wipers so as to have a clean space for the disassembled parts.
Inspect each part during disassembly for wear, scratches, and cuts. Discard the worn or
damaged parts and replace with new factory authorized parts.
O-rings are sensitive to sharp edges. Inspect closely for cuts or damage. A small cut will
cause a leak. When assembling or disassembling O-rings, use hydraulic fl uid as a lubricant
to help disassembly or installation.