3
HOW THE SWITCH WORKS:
The
“on/off”
button starts and stops the control programs. After a program has been set and saved, simply press the
“on/off”
button and temperature and time will be displayed on the readout (only one program can be set and run at a time).
When the “on/off” button is pushed the control readout will first display the temperature of the steam room, followed by the
temperature set point flashing and then the programmed steam bath time in minutes. If the room temperature is lower than
the controls set point temperature, the steam generator heating cycle will start. The heating cycle will raise the temperature
in the steam room to the preset programmed temperature during the count down of the programmed time. When the room
temperature matches the preset temperature (average steam room 115
0
F, or at your temperature setting) the control will
start and stop the heat and steam entering the room within approximately one degree of the temperature set point. Once
the control has begun the time count down cycle, you may switch the display from time to temperature and adjust the settings
by pressing either the “time” or “temperature” button and the up and down arrows.
While enjoying a steam bath you may override the programmed settings by selecting the time or temperature button. Push
the time button to display the time and arrow up or down for this steam room visit (use) only. Push the temp button and arrow
up or down to change the temperature display reading from “C” to “F”. A second push of the “temp” button while in the temp
mode, will display the set point reading for 15 seconds and can be arrowed up or down to adjust the temperature for this
steam room visit (use) only. Pressing the up or down buttons until the desired increment is reached will not affect your
programmed settings (program settings can only be changed when they are flashing).
When the count down time is complete, the display will change to the 3 red bars and the steam generator will shut off.
You may halt your steam bath program at any time by pushing the
“on/off”
button.
Quick Tips For User’s
Touch the “
on
” button...displays...steam room temp / temp shut off setting / time in minutes and arrows - time up/down.
Touch the “
temp
” button...display...changes readout to show room temperature and arrow buttons change from C to F.
2nd touch...”
temp
” button...display...changes readout to temp shut off setting and arrows buttons change - temp up/down.
Touching the time button and then the temp button changes the control to display the steam room temp. For programming
instructions see “Setting Your Program”.
SETTING YOUR PROGRAM
:
NOTE:
ONCE THE CONTROL IS TURNED ON AND DISPLAYS THE TIME, IT MAY BE PROGRAMMED BY
PRESSING AND HOLDING THE “time” OR “temp” BUTTON FOR MINIMUM - 5 - SECONDS. ONLY ONE
BUTTON AT A TIME. - SETTINGS CAN ONLY BE CHANGED WHEN DIGITS ARE FLASHING.
1.
TIME
Press and hold the
“time”
button for 5 seconds until the digits begin to flash. Press the arrow buttons up or
down to increase or decrease the amount of time to program as the default for your steam visits. Touch the time
button to lock in your setting or wait for the digits to stop flashing and automatically lock in. You have
approximately 15 seconds to complete your choice. When the control is restarted your programmed time setting
will appear as the default.
2.
TEMP Press and hold the
“temp”
button for 5 seconds until the display digits flash
“SET”
and the temperature set
point is flashing. Press the arrow buttons up or down to increase or decrease the temperature setting default
for your steam visits. Touch the temp button to lock in your settings or wait for the digits to stop flashing and
automatically lock in. You have approximately 15 seconds to complete your choice. You have completed
programming the controls startup default settings for time and temperature - congratulations!
