Page 11
14.
All models except Beta, CRF250
X
,
Husqvarna 450/510 and Gas Gas
Install the stock throw-out, with needle
bearing and flat washer on top, onto the
throw-out rod.
NOTE
: If you are missing the flat washer, it is
probably stuck to the backside of your stock
pressure plate.
15.
Beta, CRF250
X
, Husqvarna 450/510 and
Gas Gas owners only:
Install the included Rekluse throw-out
assembly with the included thrust washers
and needle bearing as shown below. A
separate note showing the same
configuration is also packaged with the throw-
out assembly.
16.
Place the lining plate onto the Rekluse
pressure plate as shown below. Index the
teeth of the lining plate into the corresponding
recesses in the Rekluse pressure plate.
17.
Install Rekluse pressure plate with lining plate
onto the Rekluse center clutch.
Hold the
pressure plate and lining plate together
while installing onto center clutch to ensure
the lining plate teeth remained indexed into
the pressure plate recesses.
18.
Install the included Rekluse springs into the
pockets of the pressure plate. Place the bolts
and sleeves into the springs and thread each
bolt in a couple of turns. Next,
rotate each
spring one turn counter-clockwise to
ensure the
spring is properly located in its
spring pocket
(see picture below).
Torque each bolt to 9 ft-lbs (12 N-m).
BOTTOM OF SPRING
LOCATED IN POCKET
