3
General Safety Instructions
Product Description
Start-up and Control
Dear customer,
The glue applicator you purchased will help you to glue parts
together more easily and more rapidly. To ensure an
optimum usage of the glue applicator we recommend that
you read these instructions thoroughly before using the
applicator for the first time. The glue guns TR 500 / 501 / 502
/ 505 / 101 let you process hotmelt sticks of 90300 mm
length and 11,3 mm approximate diameter.
The working temperature of the glue must not
be exceeded. You may find it in the technical
datasheet of the respective glue.
Overheating may lead to decomposition
which may affect the health of the user as
well as the operability of the applicator.
Once the applicator has warmed up, nozzle
and lid are very hot.
Checklist:
Plug the connecting cable into socket
TR 500 / TR 501: Are the LEDs lit?
►Green: Power / Red: Heater
Stick to the heat up time of 2 7 minutes.
Keep the nozzle free of foreign substances.
Minor leaking during heatup phase is due to hotmelt
expanding in the nozzle/heating chamber.
Loading Hot-Melt
When using the glue gun for the first time, insert a hotmelt
stick. You can process hotmelt sticks of 90 – 300 mm length
and 11,3 ± 0,2mm diameter.
When the stick is used up to the point that the feed does not
push it forward anymore, insert another hotmelt stick.
TR 500: Adjust Temperature
Never start working before fitting a nozzle first.
Only replace nozzle when applicator is warmed up. (60°
80° C device temperature).
Unplug the connecting cable, before replacing a nozzle.
Warning: risk of burns! When a nozzle is replaced, liquid
glue might leak out.
Never bring the hot nozzle into contact with the cable.
Never direct the glue jet towards people.
Always deposit the glue applicator on the wire stand or
the respective plate destined for this purpose.
Do not lay the applicator on its side.
Always keep the hot glue gun out of reach of children.
When your skin got into contact with hot glue, cool it with
cold water immediately. Do not try to remove the hotmelt
from the skin first. If necessary, consult a doctor.
When hot adhesive got into your eyes, immediately cool
them under running water for about 15 minutes and
consult your doctor at once.
● approx. 110 °C
●● approx. 130 °C
●●● approx. 155 °C
●●●● approx. 190 °C
Measured at the nozzle tip, meaning the working
temperature at ●●●● is approx. 200 °C
