Rejuvenation The Falcon, Руководство пользователя

Страница: 7 / 36

5. Route wires through motor coupling cover,
7
How to Assemble Your Ceiling Fan (continued)
5.
canopy screw cover and ceiling canopy. (Figure 5)
7. Cut off excess lead wire approximately 6 to 9
inches above top of the top of the downrod. Strip
1/2 inch from the end of each lead insulation off
wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
Canopy Screw
Cover
Ceiling
Canopy
Motor
Coupling
Cover
Figure 5
Figure 6
Figure 7
x 6
1/4˝-20
SCREWS
HARDWARE USED:
Figure 8
Blade Plate
Motor
Assembly
(2 each per blade)
Blade
(not included)
8. Secure the three blades using the 1/4˝-20 screws
with blade plate throug h the holes located on the
bottom of the motor assembly ( marked A-A, B-B, C-C) .
(Figure 8)
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
6. Reinstall the hanger ball on the downrod as
follows. Route the two 80 in. wires through the hanger
ball. Position the pin through the two holes in the
downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 6)
1/4˝-20 Screw
w/Lock Washer