Rejuvenation The Falcon, Руководство пользователя

Страница: 11 / 36

For illustrative purposes only -not
intended to cover all types of controls
11
How to Operate Your Ceiling Fan
MAIN FUSE BOX
Figure 2
Figure 1
Figure 3
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box (Figure 2).
1.
IMPORTANT:
Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
NOTE: There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Within 60 seconds of restoring power to the
fan, press and hold the “SET” button for 3-5 seconds to
set the code in the receiver. The ceiling fan lights
(if installed) will flash to indicate the remote code has
been paired with the receiver. (If not used for long
periods of time, remove battery to prevent damage to
transmitter). Store the remote away from excessive
heat or humidly (Figure 3).
Figure 4
4. The remote buttons instruct as below:
I = minimum speed II = low speed
III = medium low speed IV = medium speed
V = medium high speed VI = high speed
: Turns the fan off.
: Controls fan direction - forward and reverse.
: Controls light-Infinite light levels are available by
holding the light on/off button (Figure 4).
Fan speed:
NOTE: The light kit is optional, not included in the fan box.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.