REITEL UNICUT, Руководство по эксплуатации

Страница: 6 / 15

6
bottom with adjusted angle. Optionally the laser guide might be helpful for fine
adjustment (see accessories).
1.
Release locking screw (25), if the motor arm cannot be moved.
2. Adjust the balance weight of the motor arm by turning the weight (16) and the lock
nut (17) on the thread rod (lifting and lowering force). Move the sawing blade
upwards so that you can easily access the base (8).
3.
Move the suction funnel (6) upwards by releasing the lock lever so that the exhaust
is approximately located on a level with the model.
4.
Put the magnetic table (7) on its base (8) .
5. Adjust the depth stop (19) with the wing screw (20) so that the cutting blade doesn’t
touch the magnetic table (7)
6. Use the locking screw (23) for opening the grip jaws and fasten your plaster model.
7.
With lever (24) the table’s angle can be adjusted. Adjust the magnetic table’s
position, if necessary lower the saw blade close to the model. If available, the laser
guide will help you for exact positioning.
8.
Fasten the model table by pressing the switch (9)
9. Adjust the speed (10),
0 = approx. 1.500 t/min. for a carbide cutting blade
5 = approx. 6.000 t/min. for a standard diamond cutting blade
7 = approx. 9.000 t/min. for a diamond cutting blade, fine cut
10. The motor starts after pressing simultaneously the push button at the housing (15)
and at the handle (1).
11. Slowly saw into the model by softly lowering the motor swivel arm and if necessary
adjust the position by releasing the magnet and adjusting the table position. Please
pay attention that the saw blade doesn’t swing.
4.3 Working with the model table MODEL TRAY ® (Option), with suction adaptor
With the special model table of the MODEL TRAY ® Systems you’ll profit from this
special model system. The model tray table was optimized especially for use with the
UNICUT model saw with two-hand operation.