REITEL DUSTY COMFORT, Руководство по эксплуатации

Страница: 7 / 20

7
Installation
The equipment delivered is ready for immediate use. The sealed plug can be connected
directly to the mains supply 230 V/16 A. For installation please refer to chapter 2.
Installation
1. Ensure that the suction is switched off with the on/off switch (1).
2. Put the plug into a properly installed socket.
Hose Installation
1. Introduce the hose coupling (4) into the inlet fitting (3) of the suction (see detail 1).
2. Check for tight fit of the suction hose (4).
Filter Installation
1. Open the retaining clamps (8) and remove the upper section of the suction (6) (see detail
2).
2. Press the filter bag connection firmly onto the inlet fitting in the dirt tank (see detail 3).
3. Attach the upper section of the suction (6). Close the retaining clamps (8)(see detail 9).
Ensure that the retaining clamps fit properly.
Connection of power tools
1. Ensure that the suction is switched off with the on/off switch (1).
2. Using the connector (2) a power tool can be connected.
3. Ensure that the power tool is switched off.
4. Connect the end of the suction hose (4) with the coupling bush to the power tool.
5. Insert the plug of the power tool into the tool socket (2) on the operating panel.
Attention:
To comply with regulations, only approved dust producing tools should be connected. The
maximum power consumption of the connected electrical appliance is stated in
“Technical
Data”, chapter 9). The operating instructions incl. safety instructions for the connected
power tool have to be adhered to.