Continued.
Insert the remaining Handle half and upright,
locking it into place with the aligning lugs.
Push it in firmly until the metal ring section
is flush with the body of the case. Insert the
Hex head screws and tighten with your 4mm
Allen Key.
Flip the magnet over to reveal the skirt.
Using your Phillips screwdriver or cordless
drill (set on low) install and tighten the 8 x
retention screws.
Be sure not to overtighten
these as damage may occur to the inserts
inside the case.
The final stage is to insert all the sealing
caps. There are 4 for the handle (Red) and
tow for the Pivot screws at the rear of the
case (Orange). These can be simply pushed
in by hand and should not require blunt
force.
