REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual BASIC LIGHT 20
SERVICE MANUAL
FLIP-UP ARMREST
Until march 2020
Height adjustment.
The user can easily adjust the Flip-up armrest in height.
Turn the lever
A
and change the height using the pre-drilled
holes on the tube
B
.
That is possible only in absence of the bolt/washer/nut
C
on
the rear side of the armrest frame that have pre-drilled holes
that corresponds to those of the tube
D
.
The bolt/washer/nut
A
allows for locking the height adjust-
ment once you have decided the correct position.
It also make the armrest a little more stable (less play).
Length adjustment.
You can adjust the armrest in length in order to better adapt
it according to the seat depth of the wheelchair.
Separate the lower and upper side of the armrest by working
as for height adjustment until the two parts come apart. (If
the bolt/washer/nut
C
is present, remove it first).
Adjusting the lower part of the armrest.
Remove bolts/washers/nuts
E
.
Slide the two plates of the tube
D
frontward or backward until
aligning their holes with those on the skirt guard.
The length of the plates, at origin, allows for four positions.
The shortest length is possible only if you cut the plates 25
mm off.
Once you have chosen the length, fix the plates of the tube
D
with the bolts/washers/nuts
E
.
The adaptation may also envolve the front support
F
.
Before starting the adjustment, check if you can move the
front support
F
to another pre-drilled hole on the frame at 25
or 50 mm.
To move the support
F
, remove the bolt/washer/nut
G
and fix
the support in another position.
It is possible, like in this case, you have to fix the support
F
using the same hole where it is present the bolt that fixes the
frame. Just remove that bolt and fix it using the next hole.
Now you can fix the support.
The stability of the frame is not altered.
B
C
D
F
F
G
Frame fixing bolt
E
D
Follows next page
