ISSUED:08-20-02 SHEET #: 200-9404-9 03-21-07
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870.
3 of 5
ceiling plate (not included)
Thread support pipe (
C
) into threaded fitting in ceiling plate (
UL Listed CMJ470, not included
). Tighten - four or
five complete turns - leaving slot aligned with one small hole in the side of the ceiling plate threaded fitting. Insert
and tighten one M5 x .8 x 10 mm penta-pin screw (
E
) provided with ceiling plate as shown. Use the M5 penta-pin
tool (
I
) to tighten screw. BY HAND, insert four M10 x 1.5 x 15 mm penta-pin screws (
G
) into threaded holes in the
sides of ceiling arm box (
A
). Leave approximately 1/4" of exposed thread. Slide ceiling arm box (
A
) and fiber
washer (
F
) onto end of support pipe (
C
). Thread retaining collar (
D
) onto threaded end of support pipe (
C
). Tighten -
four or five complete turns. Slide ceiling arm box (
A
) down so that it is on top of retaining collar (
D
). Insert and
tighten one M5 x .8 x 10 mm penta-pin screw (
E
) into retaining collar (
D
) as shown. Insert one M5 penta-pin screw
(
E
) through the tab on the back of ceiling arm box (
A
). Use M5 penta-pin tool (
I
) to tighten screw just enough to
stabilize support pipe (
C
).
Note:
UL Listed ADJ or EXT extension column series can be used in combination with, or in place of support
pipe (
C
) to achieve different lengths.
E
D
C
C
A
F
D
G
1/4”
G
E
BACK OF CEILING
ARM BOX
E
