- 6 -
4. Electric Wiring
Voltage:
230 V/50 Hz
Power input (normal speed) 12 W
Power input (boost speed)
31 W
4.1 Wiring to the mains
1.
HR100W and HR30W units are equipped
with a two-speed motor.
2.
Wiring must be via a 3A circuit breaker
min.
3.
Ensure that the mains power supply is
isolated prior to installation.
4.
Remove the terminal board cover
(Fig. 10) and connect incoming wires to
the appropriate terminals, see the wiring
diagram.
5.
Replace the terminal board cover and
fi
t
the grommet (Fig. 10).
6.
Push the heat exchanger into the unit
so that the
TOP
mark points forward and
upwards (Fig. 11).
7.
Put the grille onto the front of the unit and
fasten it with the two screws provided (Fig.
11).
8.
Switch on the electrical mains and check
the operation of the unit.
terminal board cover
Fig. 11
Fig. 10
cable grommet
screws
grille
heat exchanger
