www.regentlight.co.za
www.regentlight.co.za
2
7
8
This product should be installed by a competent person i.e. Qualified electrician.
This product requires a constant stable electrical supply 220V - 240V VAC 50Hz - alternating current.
The product must be regularly maintained, including the replacement of lamps/LED timeously.
This product could be HAZARDOUS if not used correctly, it could cause electric shock, serious bodily harm or death.
This product is not a toy, please keep away from children.
This product may contain small parts that can be swallowed.
Use only the correct light bulbs/LED as stipulated on the carton for the product.
Any modifications of this product after supply will result in the guarantee being void.
Spare parts may become unavailable over time.Items can vary slightly from the picture on the carton
Coastal humidity can affect the longevity of the light fitting over time.
Be sure to follow the steps in the order given.
Read instructions carefully.
Important Safety Instructions
3
3. FINISHING THE SURFACE:
Finish the wall by plastering up to the box opening.
Clean the excess plaster around the wall box opening.
FSL
FSL
PLASTERING / FINISHING
5
5. Push the luminaire into the wall box.
Ensure that there are no exposed conductors, loose strands or trapped insulation.
FSL
FSL
FSL
INSTALLATION
4
4.
Strip the main power
supply
cable (Live, neutral and earth),
before connecting.
Separately connect the Live,
Neutral and Earth from the
mains power supply to the
electrical cable tail supplied on
the fitting using 3 resin
connectors
(Connector: 3M -
J000788)
to maintain the IP
rating.
Inset the two corresponding
cables
Push the button on the
connector (indicated in
red/orange) to release the gel
resin once the electrical cables
are secure.
Strip the cable
before connecting
Connector: 3M - J000788
x3 per bulkhead
(L) Brown/
(N) Blue/
Main supply
Light source
(E) Green/yellow
(L) Brown/
(N) Blue/
(E) Green/yellow
CONNECTION
2
DO NOT PLUG
(CONNECT) WHEN
LIVE AS IT WILL CAUSE
DAMAGE TO THE
LUMINAIRE.
Insert wall plugs
into the wall before
fastening the wall
box to the wall.
Adjust the wall box
accordingly before finishing
the wall, ensuring the wall
box is level and secure.
MOUNTING
2. Feed the electrical cable
through the cable entry
hole on the wall box by
selecting the entry point
closest to the main supply.
Insert the wall box into the
wall and secure the wall
box with wall plugs/screws.
Ensure there is no trapped
or pinched insulation.
Ensure the wall box is level
vertically and horizontally.
Finished surface level
Finished surface level
Finished surface level
Finished surface level
Finished surface level
