Regency
®
U39-11 ULTIMATE™ Freestanding Gas Stove
|
43
maintenance
Panel Glass Door Assembly
Wraparound Assembly Door
(same glass retainers as the
Panel Assembly)
PANEL GLASS
REPLACEMENT
1. Remove the door from the unit and place on a
soft surface to prevent scratching.
2. Pull out the door gasket.
3. Remove the nuts holding the glass retainers in
place.
4. Remove the glass retainers (sides, top and
bottom) and the door catch plate.
5. Replace the glass. The glass must have
gasketing around it.
6. Reverse the previous steps, replace the retainers
and fasten with the nuts but do not overtighten,
as this can break the glass. Note: the door catch
plate fits on top of the left side retainer.
7. Put gasket glue on the retainers, but do not put
glue on the screws. Replace the door gasket,
the two ends butt tight together on the bottom
edge of the door.
8. Replace door on the stove and check the seal.
LOG REPLACEMENT
The unit should never be used with broken logs. Turn
off the gas valve and allow the unit to cool before
opening door to carefully remove the logs. The pilot
light generates enough heat to burn someone. If for
any reason a log should need replacement, you
must use the proper replacement log. The position
of these logs must be as shown in the diagram
under Log Installation.
Note: Improper positioning of logs may create
carbon build-up and will alter the unit’s
performance which is not covered under
warranty.
DOOR GASKET
If the door gasket requires replacement use 7/8"
diameter oval door gasket (Part # 732-570).
LATCH ADJUSTMENT
The door latch may require adjustment as the door
gasket material compresses after a few fires and
after glass replacement. Turn the adjustable catch
to tighten or loosen the latch.
GLASS
REPLACEMENT
Your ULTIMATE stove is supplied with high
temperature, 5 mm Neoceram ceramic glass that
will withstand the highest heat that your unit will
produce. In the event that you break your glass
by impact, purchase your replacement door from
an authorized Regency
®
dealer only, and follow
our step-by-step instructions for replacement. The
glass is not sold separately, as it must be properly
sealed in the door frame.
Replacement Part #
940-325/P
U39 Wraparound Glass
WARNING: Do not operate appliance
with glass panels removed, cracked
or broken. Replacement of the glass
should be done by a licensed or
qualified service person.
Note:
Wearing gloves will protect your hands
while handling glass.
Installing Glass
1. Place glass assembly into door frame.
2. Install retainers by placing 1 drop of glue where
previously glued and put in place.
3. Install side retainers.
4. Install door catch plate.
5. Install the 24 nuts loosely, do not tighten.
6. Tighten side panels nuts using the following
procedure:
a. tighten top & bottom outside corner nuts
(2).
b. tighten inside nuts (3).
c. tighten top & bottom inside corners (2).
7. Tighten the 10 nuts on center glass retainer.
8. Repeat step 7 for other side panel.
9. Replace new gasket by gluing it in place.
10. Install door onto stove and check the seal.
Содержание U39-LP11
Страница 49: ...Regency U39 11 ULTIMATE Freestanding Gas Stove 49 notes ...
Страница 54: ......
Страница 55: ......