Regency Wood Insert & Hearth Heater
13
INSTALLATION
Pull Open
Push Closed
Hearth Heater (H2105M)
Steel Baffle
Place the insulation batt on top of the baffle.
Make sure that this batt is laying flat and does
not obstruct the smoke from getting up the flue
opening. This insulating batt may be wrapped
in paper for handling purposes and does not
require removal. Batt hold down weights are
supplied with the unit and are to be placed on
the insulation to either side of the flame spreader
as shown in the diagram and at the rear, directly
in front of the flue opening.
Lift the front end of the baffle up and over the
rear of the air tube. On Hearth Heater (H2105M)
remove center tube by sliding it sideways first
and then down.
Lift the rear of the baffle, pivoting it on the air
tube, until it clears the rear air channel.
Slide the rear of the baffle on top of the rear
air channel in front of the locating tabs. Make
sure that the insulation is lying flat and does
not obstruct the smoke from getting up the flue
opening. Place hold down weights on top of
the insulation - one on each side.
DRAFT CONTROL
Before establishing your first fire, it is important
that your fully understand the operation of you
draft control. The draft rod is on the left side of
the Inserts and it controls the intensity of the fire
by increasing or decreasing the amount of air
allowed into the firebox. To increase your draft
- pull open, and to decrease - push closed.
As well as a primary and glass wash air system,
the unit has a full secondary draft system that
allows air to the induction ports at the top of
the firebox, just below the flue baffle.
WARNING: To build a fire in ignorance or to
disregard the informa tion contained in this
section can cause serious permanent dam-
age to the unit and void your warranty.
SCREEN DOOR
Hook screen to the inside on the right side
of the firebox door opening. Lock in place by
turning handle.
Back Side of Screen Shown
WARNING
Fireplace Stoves equipped with doors
should be operated only with doors
fully closed. If doors are left partly
open, gas and flame may be drawn out
of the fireplace stove opening, creat-
ing risks from both fire and smoke.
When operated with doors open the
manufacturer supplied screen must
be used.
NOTE:
The handle must be positioned at 10
o'clock when closed to avoid the handle from
getting hot and to ensure the screen stays in
place.
Handle Lock
Hooks
Handle at 10 o'clock position.
