16
U32-5 FPI Direct Vent Gas Insert
INSTALLATION
Diagram 3
Rear View: Trim Assembly
Diagram 2
Rear View: Faceplate Assembly
Diagram 1
REGENCY FACEPLATE
& TRIM
INSTALLATION
1)
Lay the faceplate panels
fl
at, face down on
something soft so they don't scratch.
2)
Take the top faceplate and align the holes
in it with the holes in the side panels. Using
the screws provided, attach from the top of
the panel (the holes in the top panel are
slightly larger than the holes in the side panel
to facilitate easier installation). Diagram 1.
Hint: Don't tighten the screws down
completely at this point, continue on with
steps 3 and 4 and do a trial
fi
t to the unit.
Make any necessary adjustments and
when it
fi
ts properly then tighten down the
screws.
Hearth Trim Option:
Hearth Trim is an
option that can be used to
fi
nish off the
installation when the bottom of the
fi
replace
is higher than the hearth or to raise the
fi
replace. Attach the Hearth Trim to the
bottom of the faceplate side panels with the
screws provided. See Diagram 1.
3)
Using the connectors provided, join the left
side trim (with the ON/OFF switch) to the
top trim. Diagram 2. Connect the right side
trim to the top trim.
4)
Place the trim on the assembled faceplate
panels, aligning the wire connections from
the switches with the notch on the left side
panel.
5)
Connect the fan switch wires by taking the
black and red wires with the male ends (in
the grey harness) and connect them with
the wire connectors from the fan speed
control.
6)
Connect the ON/OFF switch wires by taking
the black and red wires with the female ends
and connect them to the ON/OFF switch.
7)
Tuck the wires into the faceplate to keep them
away from the insert using the clip provided.
Attach the clip to the rear of the faceplate to
ensure that the wires do not touch the side
of the unit. Diagram 3.
8)
The power cord should be run behind the
faceplate panel.
9)
Attach the brass trim to the faceplate by drilling
a 1/8" hole through into the faceplate using the
hole in the trim as a guide. Fasten the trim to
the faceplate panels using the plated screws.
Diagram 4.
10)
Attach the faceplate panels to the insert
body using the 4 remaining black screws.
Diagram 5.
Diagram 4
Diagram 5
11)
Push the Regency
®
logo plate into the
two holes in the bottom left corner of the
faceplate.
