Regada SPR 0.1PA, Инструкции по установке, обслуживанию и техническому обслуживанию, Страница: 22 / 41

20 SPR 0.1PA
3.2 Procedure for setting individual parameters and the register of errors and
warnings is given in the separate attachment 74 1053 02 of these operating
instructions.
The factory default setting of individual programmes shown in Table 2, as long as otherwise specified by the
customer:
Table 2
Factory default settings of individual parameters in version without local control; possibility to set-up
by operating the control unite buttons.
For the individual parameters set-up see appendix 74 1053 02
MENU NAME FACTORY SETTING-UP
1 SWITCHING-OFF TORQUE not valid for this type of the EA
2 END POSITION
C = Po O = Position – shutting off at end limit Open and
Closed from the position (there are no other options acceptable
for this EA type).
3
TORQUE BLOCKING TIME &
POSITION
not valid for this type of the EA
4 READY RELAY
- errors (READY COM-NO relay contacts closed in error free
conditions)
5 RELAY R1, R2
- position O for relay R1
- position C for relay R2
- from position 95% for relay RE 3
- from position 5% for relay RE 4
- disabled for R5 relay
6 CPT (output signal) 4 to 20 mA
2P
3P
7
REGULATION – (according to
specification)
CONTR. SIGNAL
- 4 to 20 mA
8 DEAD ZONE - 3 %
9 SAFE STOP
Other parameters set-up not possible to change using the PC software
TITLE
FACTORY SETTING-UP
THERMOSTAT TEMPERATURE 25 °(space heater OFF temperature)
INTERNAL DEAD ZONE 2 % (only for 3P)
SAFE POSITION 0 %
FUNCTION I1 ESD
ACTIVE I1 high level
FUNCTION I2 DISABLED
ACTIVE I2 high level
THERMAL FUSE FAILURE functionless with this EA type
THERMAL FUSE RESET
functionless with this EA type
CYCLE MODE DISABLED
CYCLE RUNNING TIME
10 s
CYCLE PAUSE 50 s
CYCLE POSITION O1 0 %
CYCLE POSITION O2 100 %
CYCLE POSITION C1 0 %
CYCLE POSITION C2 100 %
O AND C TOLERANCE 1 %
CREATE BACKUP START
RESTORE FROM BACKUP START
RESTORE FACTORY SETUP START
ACTIVE ERRORS CLEAR