Regada Rematic STR 1PA, Инструкции по установке, обслуживанию и техническому обслуживанию, Страница: 16 / 65

14 STR 1PA, STR 2PA
Version with Modbus interface:
o
Modbus, line specification: RS485, two-wire design, half duplex.
o
Modbus, Transmission Mode: RTU (8-bit binary data).
•
Variants:
o
Single Channel version with cable or component redundancy or with repeater (common
address and communication parameters).
o
Duo Channel version with cable or component redundancy or with repeater (common
address and communication parameters).
•
Address: 1 through 247
•
Parity:
o
Even (1 stop bit)
o
Odd (1 stop bit)
o
No (2 stop bits)
•
Supported transmission rates:
o
300 bit/s
o
600 bit/s
o
1200 bit/s
o
2400 bit/s
o
4800 bit/s
o
9600 bit/s
o
19200 bit/s
o
38400 bit/s
o
57600 bit/s
o
115200 bit/s
•
Signal delay (repeater):
o
max. 2.67 µs
•
Bit edge reduction/extension (repeater):
o
max. 1.67 µs
Version with Profibus interface:
o
Profibus, line specification: two-wire design, galvanic separated.
•
Variants:
o
Single Channel version.
o
Duo Channel version (simple/redundancy).
•
Adress 1: 1 ....126
•
Adress 2: 1 ....126
•
Redundancy:
o
Off (for single channel version)
o
Simple (for duo channel version)
•
Supported transmission rates:
o
9,6 kbit/s
o
19,2 kbit/s
o
93,75 kbit/s
o
187,5 kbit/s
o
500 kbit/s
o
1500 kbit/s
Control by binary inputs 24 V DC:
-
by feeding of 24 V DC to terminals CLOSE and OPEN
Programming possibilities of binary inputs I1 and I2 (change is possible only through the
programme of PC or using buttons local control)
- for the input I1 : DISABLED; ESD; DBL (local releasing - not valid for EA without local control),
STOP
- for the input
I2 : DISABLED, ESD; DBL (local releasing - not valid for EA without local control), 2P
2P resp. E2P (the EA can undergo control for the opening direction or closing with the controller ON
and I2 input activated with 24 V DC voltage supplied to the terminals to OPEN or CLOSE).
Factory’s setup is described in the chapter “Adjusting of actuator”.
Programmable FAILURE REACTION : OPEN, CLOSE, STOP, SAFE POSITION
Factory’s setup is described in the chapter “Adjusting of actuator”.
Adjustable elements of electronics:
The EA is possible to adjust with or resetting to different parameters operating the control unit buttons,
or with buttons on the local control (according to version), or once it is connected to the PC using the
programme and the communication cable connected to the EA control unit communication connector
and the EA cover removed.