28
R
The screen may prompt you to enter the service password.
4. Press the
5. Use
to enter the Service password.
Service password is 17
.
6. Press
to confirm the password. The display will read:
OFFSETS
Outside temp:
00.0
o
c
010.0
o
c
Fluid temp:
00.0
o
c
024.7
o
c
7. Press
.
8. Use
to enter the
Outside temp
offset value in Celsius. This allows you to change the outside temperature
reading.
Only for tests
. Return this value to zero for normal operation. Note that the offset is always shown in Celsius,
even if Fahrenheit has been set as the temperature unit. The offset to the reading is properly applied in the selected
temperature unit.
9. Press
to confirm your selection.
10. Use
to enter the
Fluid temp
offset value in Celsius. This allows you to change the fluid temperature reading.
Only for tests
. Return this value to zero for normal operation. Note that the offset is always shown in Celsius, even if
Fahrenheit has been set. The offset to the reading is properly applied in the selected temperature unit.
11. Press
to confirm your selection.
12. Press
, the display will read:
TEMPERATURE SETUP
Setpoint band:
Drain temp. band:
07.0
o
c
04.0
o
c
NOTE
: The message “Drain temp. must be lower than setpoint” is shown if
DRAIN TEMP.
is set above
SETPOINT
(set
under the USER menu previously explained on page 27).
13. Press
.
14. Use
to enter the temperature
Setpoint band
. Refer to the Operation Principle on page 5
and Setpoint under
the USER menu previously explained on page 27. This parameter defines the upper point of the temperature range.
15. Press
to confirm your selection.
16. Use
to enter the
Drain temp. band
. If the pipes have been drained due to low outside temperature (equal or
below the “drain temperature” point, explained under the USER menu on page 27), the operation will not restart if
outside temperature is lower than “drain temperature” + “drain temperature band”.
17. Press
to confirm your selection.
18. Press
, the display will read:
Содержание Guardian+ RC-A
Страница 1: ...R PROGRAMMING MANUAL OPTI MIST PLUS ADIABATIC CONTROL RC A VERSION 1 4...
Страница 2: ...2 R Specifications...
