24
R
83. Press
to confirm your selection.
84. Use
to set
Ck. demineralizer
to YES or NO. This allows the user to enable or disable the demineralizer service alarm.
85. Press
to confirm your selection.
86. Press
to return to the
FACTORY SETUP MENU
. The display will read:
FACTORY SETUP MENU
DELAYS
FEATURES/ALARMS EN/DIS
FACTORY RESET
87. Use
to select
DEVICES RUN HOURS
.
88. Press
to confirm your selection. The display will read:
DEVICES RUN HOURS
Are you sure to reset
this device RUN HOURS
registry?
Choose device
Save each: 12hour(s)
Seconds per hour: 3600
89. Press
.
90. Use
to select the device. This allows you to select and clear the total operating time counter of each device
(water pump, water filter cartridge, UV lights, and demineralizer). Useful if the device was replaced.
91. Press
to confirm your selection.
92. Press
until cursor returns to
Choose device
and then repeat steps 90 to 91 to reset another device.
93. Use
to enter the
Save each
value. Operating times of the previous devices are periodically saved in the
controller’s permanent memory. Set the interval at which a save is made here. The number of saves on the memory is
limited; 12 or 24 hours is recommended.
94. Press
to confirm your selection.
IMPORTANT:
Do not change the
Seconds per hour
value (3600 by default). Only used in factory for tests.
95. Press
to return to the
FACTORY SETUP MENU
. The display will read:
FACTORY SETUP MENU
FACTORY RESET
DEVICES RUN HOURS
GENERAL STATUS
Содержание Guardian+ RC-A
Страница 1: ...R PROGRAMMING MANUAL OPTI MIST PLUS ADIABATIC CONTROL RC A VERSION 1 4...
Страница 2: ...2 R Specifications...
