Installation Instructions
19K Sidewinder
TM
1. Before removing the original pin box, take note of the number of bolts used attaching the existing pin box to the
mounting wing set. Cequent Performance Products recommends using at least the same number of bolts upon
installation as removed from the original pin box. (Figure 7)
©
2009, 2016 Cequent Performance Products - Printed in Mexico
Sheet 4 of 12
SW19KIN
10/25/16
Rev. K
Form: F205 Rev A 5-6-05
ASSEMBLY INSTRUCTIONS – For Pre-Assembled OEM Models use this section as a point of reference.
Figure 7
Mounting Wing Set
2. Check all boxes for all components listed in figure 1. Locate the part information and record it on page 12.
3. Remove the existing pin box, taking care to remove any necessary wiring and/or break away switch if attached to the
pin box. (If removed, the break away switch must be reinstalled after installation is complete)
5. Install pivot bushing into the turret as shown in figure 8. Applying white lithium grease to the inner tube of the turret may
ease assembly. Install wear plate onto sidewinder arm (Figure 9), be sure to place the chamfer facing down
(Figure 10). Apply white lithium grease to the surfaces shown in figure 11, be sure to coat the entire surface.
The chamfer on the wear plate Must face down as shown
Figure 8
Figure 10
Figure 9
Apply White
Lithium Grease
Figure 11
4. Check that the new turret fits into the mounting wing set and that the holes align.
Figure 12
Upper Wear Disc
Outer Cap
(4) 5/8” Conical Washer
(4) 5/8”-11 GR 8 Bolt
(See Figure 14 for Torque)
7.
Install the upper wear disc and outer cap. Install (4) 5/8” Cap
bolts & 5/8” conical washers, do not fully tighten these bolts
at this time (figure 12).
6. Install turret onto Sidewinder
TM
arm over the wear plate.
